Měření drsnosti povrchu obráběných free-form ploch
Machined free-form surface rougness measurement
Typ dokumentu
bakalářská prácebachelor thesis
Autor
Tomáš Havránek
Vedoucí práce
Tomíček Jan
Oponent práce
Vacek Josef
Studijní obor
Technologie, materiály a ekonomika strojírenstvíStudijní program
Výroba a ekonomika ve strojírenstvíInstituce přidělující hodnost
ústav technologie obrábění, projektování a metrologiePráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato práce se zabývá měřením drsnosti povrchu free-form ploch po obrábění. Cílem je zjistit vhodnou metodu měření těchto ploch. Byla provedena rešerše na téma výroby free-form ploch a měření drsnosti na těchto plochách. Následovala rešerše v oblasti normalizace v oblasti měření drsnosti. V praktické části práce je popsán návrh experimentálního tělesa a měření drsnosti na navrženém tělese. Závěrem je porovnání různých metod měření drsnosti a vyhodnocení celé práce. This thesis deals with the measurement of surface roughness of free-form surfaces after machining. The aim is to determine a suitable method for measuring these surfaces. Research has been carried out on the topic of manufacturing of free-form surfaces and measuring the roughness on these surfaces. This was followed by a research on standardization in the field of roughness measurement. The practical part of the thesis describes the design of the experimental solid and the measurement of roughness on the designed solid. Finally, a comparison of different methods of roughness measurement and an evaluation of the whole work is presented.
Kolekce
- Bakalářské práce - 12134 [366]