Dokončování povrchu žárových nástřiků
Finishing of the thermal sprayed surfaces
Typ dokumentu
diplomová prácemaster thesis
Autor
Monika Kostková
Vedoucí práce
Pelikán Lukáš
Oponent práce
Neišl Valdemar
Studijní obor
Bez specializaceStudijní program
Výrobní inženýrstvíInstituce přidělující hodnost
ústav technologie obrábění, projektování a metrologiePráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato diplomová práce popisuje nejběžnější druhy žárových nástřiků, jejich využití a vlastnosti. Po nanesení nástřiku jsou některé hodnoty nedostačující a povrch je třeba dále dokončovat. Část práce je proto věnovaná brusným materiálům, nástrojům a strojům, kterými lze pomocí flexibilního broušení dosahovat požadovaných parametrů. Dále jsou shrnuty i další metody, kterými lze žárové nástřiky dokončovat. Praktická část je zaměřena na testování tří zvolených způsobů broušení těchto nástřiků, a to broušení pomocí diamantového fíbrového kotouče, broušení diamantovým a keramickým brusným pásem a broušení kotoučem z netkané textilie. Cílem práce je seznámit čtenáře s danou problematikou a otestovat vybrané metody dokončování žárových nástřiků pro další vývoj a optimalizaci. This diploma thesis describes the most common types of thermal spraying, their use and properties. After spraying, some values are insufficient and the surface needs to be further finished. Part of the work is therefore devoted to abrasives, tools and machines, which can be used to achieve the required parameters through flexible grinding. Other methods suitable for finishing thermal sprayed surfaces are also summarized. The practical part is focused on testing of three selected methods of grinding sprayed surfaces, namely grinding with a diamond fiber wheel, grinding with a diamond and ceramic sanding belt and grinding with a non-woven wheel. The aim of the work is to acquaint the reader with the given issue and to test selected methods of finishing thermal sprayed surfaces for further development and optimization.
Kolekce
- Diplomové práce - 12134 [225]