Monitoring sesuvu u Třebenic
Monitoring of landslide near Třebenice
Typ dokumentu
diplomová prácemaster thesis
Autor
Háva Jakub
Vedoucí práce
Urban Rudolf
Oponent práce
Štroner Martin
Studijní obor
Geodézie a kartografieStudijní program
Geodézie a kartografieInstituce přidělující hodnost
katedra speciální geodézieObhájeno
2017-06-22Práva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato diplomové práce se zabývá zaměřením bodů, které jsou podezřelé z posunu. Měření bylo provedeno ve dvou etapách. Cílem práce je určení výsledných polohových i výškových posunů těchto bodů. Měření bylo provedeno v sesuvném území mezi Třebenicemi a Dlažkovicemi. Sledované body byly stabilizovány na zabetonovaných ocelových tyčí. V obou etapách byl polygonový pořad zaměřen pomocí trojpodstavcové sestavy a byl připojen na 2 fixní body, na kterých proběhla GNSS observace. Obě etapy byly vyrovnány v programu EasyNET a porovnány mezi sebou. Výsledné posuny jsou uvedeny v přehledných tabulkách. This diploma thesis deals with the focusing of points that are suspicious of the shift. The measurements were carried out in two stages. The aim of the thesis is to determine the resulting positional and height displacements of these points. The measurements were made in the sliding area between Trebenice and Dlažkovice. The observed points were stabilized on the reinforced steel bars. In both stages, the polygon program was targeted by a three-stacked assembly and was connected to 2 fixed points on which GNSS observations were made. Both stages were aligned in EasyNET and compared to each other. The resulting shifts are shown in the tables.
Kolekce
- Diplomové práce - 11154 [132]