Posouzení stavu Juditiny věže
Judith's Tower Condition Assessment
Typ dokumentu
bakalářská prácebachelor thesis
Autor
Václav Urban
Vedoucí práce
Fajman Petr
Oponent práce
Burgetová Eva
Studijní obor
Konstrukce pozemních stavebStudijní program
Stavební inženýrstvíInstituce přidělující hodnost
katedra mechanikyObhájeno
2023-06-28Práva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Práce se zabývá zjištěním stavu historické konstrukce s pořízením fotografické dokumentace a se zakreslením trhlin. Následně byl vytvořen statický počítačový model. V modelu byly zavedeny pružné okrajové podmínky, které se upravovaly tak, aby výsledná napětí odpovídala pozorovaným trhlinám. Musel být upraven i model stropní konstrukce v závislosti na rozdílu skutečných a modelových rozměrech. Materiálové charakteristiky a zatížení byly vypočteny podle norem. Maximální užitné zatížení bylo určeno podle maximální únosnosti stropů. Na závěr byl porovnán výskyt a směr hlavního tahového napětí v modelu s polohou trhlin in situ. The work deals with the determination of the condition of the historical structure with photographic documentation and drawing of cracks. Subsequently, a static computer model was created. Elastic boundary conditions were introduced in the model and adjusted so that the resulting stresses matched the observed cracks. The model of the floor structure also had to be adjusted depending on the difference between the actual and model dimensions. Material characteristics and loads were calculated according to the standards. The maximum imposed loads was determined according to the maximum load capacity of the ceilings. Finally, the occurrence and direction of the main tensile stress in the model was compared with the position of the cracks in situ.