Návrh automatické linky pro kontrolu kvality
Automated Inspection Line Design
Typ dokumentu
diplomová prácemaster thesis
Autor
Kamil Moudrý
Vedoucí práce
Kyncl Jiří
Oponent práce
Cikánek Martin
Studijní obor
bez oboruStudijní program
Průmysl 4.0Instituce přidělující hodnost
ústav mechaniky, biomechaniky a mechatronikyPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato diplomová práce je zaměřena na návrh automatizace kontrolního stanoviště komínových vložek. V úvodu práce je představena společnost P-D Refractories CZ a.s. V další fázi je představen koncept Průmyslu 4.0 a jeho možné implementace do reálného provozu. V další části diplomové práce je popsána problematika automatizace zpracovatelského průmyslu, včetně možností automatizace pomocí robotických manipulátorů. Další část popisuje možnosti automatizace procesu kontroly. V praktické části je provedena analýza současného stavu kontrolního stanoviště. Pomocí získaných informací a předem určených okrajových podmínek jsou navržena řešení pro automatizace tohoto procesu. V závěrečné části diplomové práce je provedeno zhodnocení návrhů z ekonomického a technologického hlediska. This diploma thesis is focused on the proposal of automatization of control points of chimney inserts. In the introduction the company P - D Refractories is presented. In the next part the concept of Industry 4.0 and its possible implementations into actual operation are introduced. Further the diploma thesis is describing problems of automatization of manufacturing industry, including the possibilities of automatization using robotic manipulators. In the next part, possibilities of automatization of the control process is already described. Practical part carries out the analysis of current state of control points. Using gained information and peripheral conditions specified in advance, the solutions for automatization of this process are proposed. In the final section of this thesis an evaluation of proposals from the economic and technology perspectives is performed.
Kolekce
- Diplomové práce - 12105 [211]