Soustružení kompozitního materiálu s termoplastickou matricí
Turning of fibre reinforced thermoplastic composite
Typ dokumentu
diplomová prácemaster thesis
Autor
Michal Bucko
Vedoucí práce
Zeman Pavel
Oponent práce
Vilcsek Igor
Studijní obor
Výrobní a materiálové inženýrstvíStudijní program
Strojní inženýrstvíInstituce přidělující hodnost
ústav technologie obrábění, projektování a metrologiePráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato práce se zabývá možnostmi měření teploty řezání při soustružení polymerního materiálu PEEK s vyztužujícími uhlíkovými vlákny pomocí přirozeného termočlánku a vlivem řezných parametrů na velikost sil řezání při soustružení stejného materiálu. Práce je rozdělena na dvě části, a to rešeršní část a vlastní experiment. V rešeršní části je popsán obecný úvod do problematiky obrábění, metodika měření sil a teplot při soustružení a současný stav na poli obrábění kompozitních materiálů. Experimentální část je zaměřena na konstrukci a ověření funkce přirozeného termočlánku při soustružení polymerního materiálu PEEK s vyztužujícími uhlíkovými vlákny a na konkrétní experiment měření sil při soustružení stejného materiálu. This paper deals with the possibilities of measuring the cutting temperature of PEEK carbon fiber reinforced material using a natural thermocouple and the influence of cutting parameters on the cutting forces of the same composite materials. The thesis is divided into two parts, namely the research section and the experiment itself. The research partdescribes the general introduction to machining, methodology of measurement of forces and temperatures during turning and current state in the field of machining of composite materials. The experimental part is focused on the construction and verification of the function of the natural thermocouple during the turning of PEEK polymer material with reinforcing carbon fibers and on the concrete force measurement experiment during the turning of the same material.
Kolekce
- Diplomové práce - 12134 [225]