Provedení rozboru mikrostruktury se zaměřením na porozitu slitiny Inconel 713LC ve vazbě na změřené mechanické vlastnosti
Microstructure analysis with a focus on the porosity of Inconel 713LC alloy in relation to the measured mechanical properties
Type of document
diplomová prácemaster thesis
Author
Lukáš Jeníček
Supervisor
Horváth Jakub
Opponent
Zýka Jiří
Field of study
Bez specializaceStudy program
Výrobní inženýrstvíInstitutions assigning rank
ústav materiálového inženýrstvíRights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Show full item recordAbstract
Práce se zabývá studiem porozity a jejího vlivu na mechanické vlastnosti niklové superslitiny INCONEL 713LC. Jejím cílem bylo zjištění korelace mezi porozitou a mechanickými vlastnostmi dané slitiny. U vzorků byla změřena porozita pomocí počítačové tomografie a plošné analýzy. Byly provedeny tahové a rázové zkoušky. Po mechanických zkouškách byla provedena obrazová analýza, kde se hodnotily póry v lomu, celkové ploše a objemu. Dále pak byla hodnocena mikrostruktura a velikost zrna. Zjištěná porozita byla porovnána se zjištěnými mechanickými vlastnostmi. Bylo zjištěno že porozita v takto nízkých hodnotách nemá vliv na mechanické vlastnosti pro konkrétní slitinu. The thesis deals with the study of porosity and its influence on the mechanical properties of nickel superalloy INCONEL 713LC. The aim was to establish the correlation between porosity and mechanical properties of the alloy. The porosity of the samples was measured by computed tomography and area analysis. Tensile and impact tests were carried out. After mechanical testing, image analysis was performed to evaluate the fracture pores, total area and volume. Furthermore, the microstructure and grain size were evaluated as well. The observed porosity was compared with the observed mechanical properties. It was found that porosity at such low values does not affect the mechanical properties for a particular alloy.
Collections
- Diplomové práce - 12132 [102]