Porovnání procesů plazmového řezání
Comparison of plasma cutting processes
dc.contributor.advisor | Kolařík Ladislav | |
dc.contributor.author | Jan Horáček | |
dc.date.accessioned | 2021-02-04T23:51:30Z | |
dc.date.available | 2021-02-04T23:51:30Z | |
dc.date.issued | 2021-02-04 | |
dc.identifier | KOS-859288951505 | |
dc.identifier.uri | http://hdl.handle.net/10467/93183 | |
dc.description.abstract | Bakalářská práce se zabývá problematikou plazmového řezání. V práci je dále popsána historie, princip plazmového řezání, sestavení hořáků, další metody řezání a technické plyny. Experimentální část se zabývá porovnáním metod Silent cut a Contour cut. U obou metod byl porovnáván řez z hlediska drsnosti povrchu, kolmosti, tvrdosti, tepelně ovlivněné oblasti a hluku při řezání na 6 vzorcích z materiálu S235. | cze |
dc.description.abstract | The bachelor thesis deals with the issue of plasma cutting. The paper also describes the history, the principle of plasma cutting, assembly of torches, other cutting methods, and technical gases. The experimental part is concerned with the comparison of Silent Cut and Contour Cut methods. For both methods, the section was compared in terms of surface roughness, perpendicularity, hardness, heat affected area, and noise when cutting on 6 samples of S235 material. | eng |
dc.publisher | České vysoké učení technické v Praze. Vypočetní a informační centrum. | cze |
dc.publisher | Czech Technical University in Prague. Computing and Information Centre. | eng |
dc.rights | A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.html | eng |
dc.rights | Vysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html | cze |
dc.subject | Plazmové řezání | cze |
dc.subject | Contour cut | cze |
dc.subject | Silent cut | cze |
dc.subject | Plasma cutting | eng |
dc.subject | Contour cut | eng |
dc.subject | Silent cut | eng |
dc.title | Porovnání procesů plazmového řezání | cze |
dc.title | Comparison of plasma cutting processes | eng |
dc.type | bakalářská práce | cze |
dc.type | bachelor thesis | eng |
dc.contributor.referee | Kovanda Karel | |
theses.degree.discipline | Technologie, materiály a ekonomika strojírenství | cze |
theses.degree.grantor | ústav strojírenské technologie | cze |
theses.degree.programme | Výroba a ekonomika ve strojírenství | cze |
Soubory tohoto záznamu
Tento záznam se objevuje v následujících kolekcích
-
Bakalářské práce - 12133 [278]