Validation tool for anchor analysis software
Validation tool for anchor analysis software
Typ dokumentu
diplomová prácemaster thesis
Autor
Jakub Nachtmann
Vedoucí práce
Šulc Rostislav
Oponent práce
Kolda Martin
Studijní obor
Příprava, realizace a provoz stavebStudijní program
Stavební inženýrstvíInstituce přidělující hodnost
katedra technologie stavebPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Autor se v této diplomové práci zabývá problematikou návrhu dodatečného kotvení. Konkrétně se jedná o výpočetní software pro návrh dodatečného kotvení. Autor bude detailně zkoumat dopad jednotlivých vstupních parametrů na celkové zatížení/využití navrhovaného kotvení a vybere nejkritičtější kombinace vstupních parametrů. Autor následně vytvoří výpočetní šablonu pro ověření únosnosti kotvení (dle EN 1992-4: 2018), která bude poté využívána pro ověření správnosti implementace nových kotevních prvků výrobce. Autor nejdříve provede zkoušku funkčnosti vytvořené výpočetní šablony na již zavedeném prvku a následně pomocí již ozkoušené výpočetní šablony ověří nově implementovaný prvek. Při ověření prvku budou využity nejkritičtější kombinace vstupních parametrů vybrané v první části práce. In this thesis, the author deals with the issue of design of post-installed anchoring. Specifically, deals with the analysis software for additional anchor design. The author will examine in detail the impact of individual input parameters on the overall anchor stress/utilization of the proposed anchor and will select the most critical combinations of input parameters. The author then creates a calculation template to verify the anchor capacity (according to EN 1992-4: 2018), which will be used to verify the implementation of the new anchor elements of the manufacturer. The author first performs a functional check of the created calculation template on the already introduced anchor element and then by using the already tested calculation template verifies the newly implemented anchor element. For verifying this anchor element, the most critical combinations of input parameters selected in the first part of the work will be used.
Kolekce
- Diplomové práce - 11122 [602]