Návrh zkušebního zařízení pro realizaci Junkersova vibračního testu dle normy DIN 65151
Test Stand for the Implementation of the Junkers Vibration test According to the DIN 65151 Standard Design
Typ dokumentu
diplomová prácemaster thesis
Autor
Vít Gracík
Vedoucí práce
Kanaval Jan
Oponent práce
Flek Jan
Studijní obor
Transportní technikaStudijní program
Dopravní a transportní technikaInstituce přidělující hodnost
ústav konstruování a částí strojůPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Cílem této diplomové práce je Návrh zkušebního zařízení pro realizaci Junkerova vibračního testu dle normy DIN 65151. Úvod práce je věnován rešerši závitů, šroubových spojů, pojišťování šroubových spojů a dostupných norem pro vibrační testování šroubových spojů. V Práci je dále proveden konstrukční návrh zařízení obsahující 3D model, 2D sestavný výkres, pevnostní a kontrolní výpočty vybraných konstrukčních uzlů, výběr nakupovaných komponent, a hrubý cenový odhad nákladů za materiál a nakupované součásti. The aim of this thesis is to design a test rig for the implementation of the Junker vibration test according to DIN 65151. The introduction of the thesis is devoted to the research of threads, bolted connections, securing of bolted joints and available standards for vibration testing of bolted joints. The thesis also presents a design of the device including a 3D model, 2D assembly drawing, strength and control calculations of selected structural nodes, selection of purchased components, and rough cost estimates for materials and purchased components
Kolekce
- Diplomové práce - 12113 [203]