Navrhování krátkých konzol prefabrikovaného sloupu
Design of corbels of precast column
Typ dokumentu
bakalářská prácebachelor thesis
Autor
Tomáš Janoušek
Vedoucí práce
Frantová Michaela
Oponent práce
Bílý Petr
Studijní obor
Konstrukce pozemních stavebStudijní program
Stavební inženýrstvíInstituce přidělující hodnost
katedra betonových a zděných konstrukcíObhájeno
2023-06-27Práva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Bakalářská práce se zabývá návrhem krátkých konzol výrobní prefabrikované haly zatížené jeřábovou drahou. Pro navržené varianty konzol bylo provedeno vyztužení podle metody náhradní příhradové analogie, které bylo porovnáno s vyztužením podle normy ČSN EN 1992 1-1. Pro navržené varianty byl zkoumán vliv náběhu na únosnosti a byl porovnán rozdíl chování krátké a dlouhé konzoly. Zkoumána byla také limitní zatížení, pro které lze konzoly vyztužit běžnou betonářskou výztuží. Výsledky této práce ukazují rozdíly v navrhování různými metodami, vliv náběhu na únosnosti a spotřebě materiálu, limitní možnosti vyztužení a rozdílné chování konzol. The bachelor thesis deals with the design of short corbels of a precast production hall loaded with a crane track. For the designed variants of the corbels, the reinforcement was performed according to the method of strut and tie modelling, which was compared with the reinforcement according to ČSN EN 1992 1-1. For the proposed variants, the effect of gradually increasing section of corbel towards the column on its load-bearing capacity was investigated and the difference in behaviour of the short and long corbel was compared. The limit loads for which the cantilevers can be reinforced were also investigated. The results of this work show the differences in the design using different methods, the effect of gradually increasing section of corbel towards the column on load capacity and material consumption, the limiting possibilities of reinforcement and the different behaviour of the cantilevers.
Kolekce
- Bakalářské práce - 11133 [560]