Příprava povrchů kompozitů, kovů a termoplastů pro lepení
Preparation of surfaces of composites, metals and thermoplastics for bonding
Typ dokumentu
diplomová prácemaster thesis
Autor
Marek Langr
Vedoucí práce
Kolařík Ladislav
Oponent práce
Šedivý Otomar
Studijní obor
Výrobní a materiálové inženýrstvíStudijní program
Strojní inženýrstvíInstituce přidělující hodnost
ústav strojírenské technologiePráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Diplomová práce se zabývá přípravou povrchů kompozitů, kovů a termoplastů pro lepení různých kombinací těchto materiálů. Cílem diplomové práce je navrhnout a experimentálně ověřit nejvhodnější variantu přípravy povrchu a proces lepení pro spojení kovu s kompozitem, jak po technologické stránce, tak i po stránce ekonomické. Práce je rozdělena na teoretickou a praktickou část. V teoretické části jsou vymezeny základní pojmy a mimo jiné popsán vznik lepeného spoje, dělení lepidel a příprava povrchů pro proces lepení. V praktické části byly navrhnuty a následně ověřeny možnosti příprav povrchů pro lepení spojení uhlíkového kompozitu s ocelí DC01, PA6 a ABS. Příprava vzorků pro experiment probíhala ve firmě Mubea v Žebráku a v laboratořích ČVUT Fakulty strojní. The thesis deals with the preparation of surfaces of composites, metals and thermoplastics for bonding various combinations of these materials. The aim of this thesis is to design and experimentally verify the most suitable variant of surface preparation and bonding process for joining metal to composite, both technologically and economically. The thesis is divided into theoretical and practical part. The theoretical part defines the basic concepts and describes, the formation of an adhesive bond, the separation of adhesives and the preparation of surfaces for the bonding process. In the practical part were designed and subsequently verified possibilities of preparation of surfaces for bonding of carbon composite with steel DC01, PA6 and ABS. The preparation of samples for the experiment took place in the company Mubea in Žebrák and in the laboratories of ČVUT of the Faculty of Mechanical Engineering.
Kolekce
- Diplomové práce - 12133 [236]