Vliv tepelné vodivosti postřiku kovové formy na kvalitu odlitku ze slitiny Al-Si
The die coatring influence of heat conduction on Al-Si alloy casting quality
Type of document
diplomová prácemaster thesis
Author
Rašovec Václav
Supervisor
Herman Aleš
Opponent
Kotas Petr
Field of study
Výrobní a materiálové inženýrstvíStudy program
Strojní inženýrstvíInstitutions assigning rank
ústav strojírenské technologieDefended
2017-09-04Rights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Show full item recordAbstract
Tato diplomová práce se zabývá fyzikálními vlastnostmi postřiků kovových forem a to konkrétně jejich tepelnou vodivostí. Experiment, který zkoumal vlastnosti postřiků, se realizoval ve společnosti BENEŠ a LÁT a.s. Při navrhování experimentu byl kladen vysoký důraz na to, aby podmínky, za kterých se daný postřik (či jejich kombinace) zkoumal, co možná nejvíce odpovídaly skutečnému výrobnímu procesu. Hlavním cílem tohoto experimentu byla korekce vstupních parametrů do simulačního softwaru, za potom zjištění skutečných hodnot koeficientů přestupu tepla mezi taveninou a stěnou formy. Zjištěné hodnoty byly následně ověřeny simulačním softwarem MAGMA5 a porovnány se skutečným procesem sériové výroby odlitku pro renomovaného zákazníka. This diploma thesis deals with the physical properties of sprays of metallic forms, namely their thermal conductivity. An experiment that investigated the properties of spraying was carried out at BENEŠ and LÁT a.s. During the design of the experiment, the emphasis was placed on the conditions whcn the spraying (or combination thereof) was investigated, as closely as possible to the actual production process. The main goal of this experiment was to correct the input parameters in the simulation software by detecting the actual values of heat transfer coefficients between the melt and the mold wall. The detected values were subsequently verified by the MAGMA5 simulation software and compared to the actual serial process. For castings production to importem customer.
Collections
- Diplomové práce - 12133 [236]