Testování kloubových hřídelí na zkušebním stanovišti.
Testing of joint shafts.
Typ dokumentu
diplomová prácemaster thesis
Autor
Michal Marčík
Vedoucí práce
Pakosta Jiří
Oponent práce
Hrnčíř Jan
Studijní obor
Motorová vozidlaStudijní program
Dopravní a transportní technikaInstituce přidělující hodnost
ústav automobilů, spalovacích motorů a kolejových vozidelPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Práce se zabývá testováním kloubových hřídelí z hlediska zahřívání za provozu a měřením odporu posuvného kloubu proti axiálnímu posunutí. První část tvoří rešerše hnacích hřídelí, kloubů a jejich vlastností. V druhé části jsou popsána zkušební stanoviště a zkoušky kloubových hřídelí. Třetí část se zabývá způsobem měření odporu kloubu proti axiálnímu posunutí. Za tímto účelem bylo vyvinuto nové zařízení pro měření přesuvné síly kloubu za rotace a zatížení velikým točivým momentem. Čtvrtá část popisuje měření zahřívání kloubů na zkušebním stanovišti. Jsou zde diskutovány různé jevy a výsledky zkoušek provedených v rámci této práce. The thesis deals with testing of joint shafts in terms of heat generation during operation and measuring of resistive force against axial displacement of plunging constant velocity joint. The first part of the thesis is a literature review that consists of describing driveshafts, joints and their properties. The second part describes test stands and tests of joint shafts. The third part deals with methods for resistive force measuring. For purposes of measuring of driveshaft plunging force under heavy torque load during rotation, new measuring device was developed. The fourth part describes measuring of joint heating on test stand. Various phenomena and results of measurements done within this thesis are discussed.
Kolekce
- Diplomové práce - 12120 [429]