Hledat
Zobrazují se záznamy 121-130 z 1342
The Timber-Precast UHPC Composite Connection
(Trans Tech Publications, 2018)
This paper deals with the connection of timber beams and precast concrete slabs. The connection of timber and concrete has many advantages associated with the efficient use of both materials, not only in terms of their ...
Mechanical properties of concrete composites subject to elevated temperature
(Elsevier B.V., 2018)
Fire resistance represents an important parameter which is necessary to consider during the structural design of buildings. It is defined as an ability of building components to perform their intended load-bearing functions ...
Local Turbulent Energy Dissipation Rate in an Agitated Vessel: Experimental and Turbulence Scaling
(Pleiades Publishing Ltd., 2018)
The hydrodynamics and the flow field in an agitated vessel were measured using 2-D time resolved particle image velocimetry (2-D TR PIV). The experiments were carried out in fully baffled cylindrical flat bottom vessels ...
Model Predictive Direct Power Control of Four-Switch-Based Inverter Connected to Unbalanced Grid System
(IEEE, 2018)
A model based predictive direct power control with finite set of control variables for the three phase four-switch-based converter B4 connected to an unbalanced grid is introduced. The instantaneous active and non-active ...
Long-Term Monitoring of Concrete Building Structure
(Trans Tech Publications, 2018)
Long-term deformations of the concrete are important for determination of behavior of concrete structures. For prediction of the long-term deformations rheological models are used. The models are usually derived from ...
Work-Life Balance as Rediscovered Modern Trend in HR Management
(Trenčianská univerzita Alexandra Dubčeka v Trenčíně, 2015)
The paper addresses the issue of work-life balance (WLB) as a modern trend in Human Resources Management, while the term was coined in 1986 and the concept itself exists from mid-1800s, if not considering Seneca´s thoughts. ...
Numerical Evaluation of Contact Blast Experiment Using LS-Dyna
(Department of Concrete and Masonry Structures, 2017)
The paper presents gained knowledge from numerical simulations of full scale experimental programme focused on behaviour and resistance of concrete panels under contact explosion. The experimental measurements took place ...
Application of laser shock processing
(Univerzita J. E. Purkyně, 2015)
Laser Shock Processing (LSP), or strengthening the material surface by laser shock wave is very modern and progressive technique, which allows a significant increase in fatigue life of cyclically loaded parts. The compressive ...
Analysis of deep beam placed in school building
(Department of Concrete and Masonry Structures, 2017)
The paper focuses on deep beam design using Strut-and-tie model method. Several computational plated models are made at the beginning. A Strut-and-tie model is created after analysis of their behaviour and deflections. ...
Improvement on mechanical and flame retardancy behaviour of bio-exfoliated graphene-filled epoxy/glass fibre composites using compression moulding approach
(Springer, 2021)
Bio-reduction of composite materials is the modern approach to facilitate the researchers to avoid toxic chemical exposure during reduction process. In this study, the green reduction of graphene oxide using Abutilon indicum ...