• The Effect of Coatings on Cutting Force in Turning of C45 Steel 

      Autor: Kovalčík J.; Mašek P.; Malý J.; Kožmín P.; Syrovátka J.
      (MDPI, 2022)
      This article focuses on the development of a mathematical model of a cutting force that is applicable for coated and uncoated cutting tool inserts and aims to enable more accurate calculation of the cutting force. Two ...
    • Hlavní trendy EMO Hannover 2017 očima výzkumníků 

      Autor: Kolář P.; Burian D.; Hornych J.; Novotný L.; Horejš O.; Mareš M.; Brajer J.; Zeman P.; Stach E.; Malý J.; Chládek Š.; Kopačka J.; Sova J.; Vrba P.; Šimůnek A.; Koubek J.; Sulitka M.; Vyroubal J.
      (MM Publishing, 2017)
      Hannoverský veletrh EMO je právem považován za výkladní skříň toho nejlepšího, co inovační týmy světových leaderů i jejich následovníků navrhli a v prototypech či již sériově nabízejí. Sektor výrobních strojů bývá na špici ...
    • Identifying the lead angle limit to achieve required surface roughness in ball-end milling 

      Autor: Pešice M.; Vavruška P.; Falta J.; Zeman P.; Malý J.
      (Springer, 2022)
      When milling generally shaped surfaces with a ball-end milling tool, machined surface roughness and accuracy as well as machining productivity are often monitored. Improving one of these parameters often causes a decrease ...
    • Increasing Tool Life through Adjustment of Cutting Edge and Toolpath during Milling of Inconel 718 

      Autor: Vavruška P.; Malý J.; Novotny A.
      (MM Science Journal, 2022)
      This paper focuses on analysis of tool life during milling of nickel alloy Inconel 718. Several modifications of one type of carbide tool with different cutting edge finish adjustments (lapping, drag finishing) were proposed ...
    • Turning of titanium alloy with PCD tool and high-pressure cooling 

      Autor: Mašek P.; Malý J.; Zeman P.; Heinrich P.; Alagan N.T.
      (Elsevier, 2022)
      Titanium alloys are difficult to cut materials due to their low thermal conductivity, which leads to intensive tool wear. The general issue is finding the best combination of cutting tool material and cutting conditions ...