Show simple item record



dc.contributor.authorProcházka V.
dc.contributor.authorKulha P.
dc.contributor.authorIzsák T.
dc.contributor.authorUkraintsev E.
dc.contributor.authorKromka A.
dc.date.accessioned2022-03-23T12:19:56Z
dc.date.available2022-03-23T12:19:56Z
dc.date.issued2022
dc.identifierV3S-356717
dc.identifier.citationPROCHÁZKA, V., et al. Detection of globular and fibrillar proteins by quartz crystal microbalance sensor coated with a functionalized diamond thin film. Applied Surface Science. 2022, 589 153017-1-153017-8. ISSN 0169-4332. DOI 10.1016/j.apsusc.2022.153017.
dc.identifier.issn0169-4332 (print)
dc.identifier.issn1873-5584 (online)
dc.identifier.urihttp://hdl.handle.net/10467/100255
dc.description.abstractThis study presents a sensor based on quartz crystal microbalance (QCM) coated with nanocrystalline diamond (NCD) thin film, functionalization method and novel application of such sensor. Diamond-coated QCMs (DQCMs) were superficially terminated by hydrogen and oxygen (H-NCD and O-NCD) to control its surface dipole/potential. Two protein solutions were tested: bovine serum albumin (BSA) and fibronectin (FN). We performed reference measurements of serial resonant frequency (SRF) of clean QCMs loaded with protein and compared them with SRF shifts DQCMs loaded with proteins. In order to investigate the influence of the deposited NCD thin film on QCM measuring capabilities, additional FEM analysis was performed. The simulation results showed that QCM sensors maintain the sensing capabilities with a rigid thin film of NCD on its surface. The shift of SRF was demonstrably caused by the weight of protein adhered to the diamond film's surface. We compared masses estimated from the Sauerbrey equation to characterize the adhesive properties of the studied proteins. Comparing bare QCM and DQCM, we discovered diamonds enhance the sensing performance for proteins. At the same time, it saturates quickly with phosphate buffer saline used as a diluent solution for proteins. Results showed a significant increase in protein adhesion confirmed by the increase of the mass for both oxygen and hydrogen-terminated DQCMs. Moreover, a different time-dependent behaviour (i.e. different adsorption rate, degrees of physisorption and/or preference of the diamond surface functionalization) of the O-NCD and H-NCD QCMs was observed for BSA and FN proteins. In this meaning, we propose a schematic model which describes the detection principle of BSA and FN proteins on H- and O-terminated DQCM sensors. Finally, a simple proof of concept for using the functionalized diamond-coated sensors with current stimulation and EQCM (Electrochemical Quartz Crystal Microbalance) is also proposed.eng
dc.format.mimetypeapplication/pdf
dc.language.isoeng
dc.publisherElsevier
dc.relation.ispartofApplied Surface Science
dc.subjectNCD Diamond QCM BSA FN Biosensors Functionalizationeng
dc.titleDetection of globular and fibrillar proteins by quartz crystal microbalance sensor coated with a functionalized diamond thin filmeng
dc.typečlánek v časopisecze
dc.typejournal articleeng
dc.identifier.doi10.1016/j.apsusc.2022.153017
dc.rights.accessclosedAccess
dc.type.statusPeer-reviewed
dc.type.versionpublishedVersion
dc.identifier.scopus2-s2.0-85126027626


Files in this item


This item appears in the following Collection(s)

Show simple item record