Prohlížení Acta Polytechnica. 2016, vol. 56, no. 5 dle názvu

Zobrazují se záznamy 6-10 z 10

    • CYCLIC STRESS ANALYSIS OF POLYESTER, ARAMID, POLYETHYLENE AND LIQUID CRYSTAL POLYMER YARNS 

      Autor: Vannucchi de Camargo , Felipe; Marcos Guilherme Eduardo, Carlos; Fragassa , Cristiano; Pavlovic , Ana
      (České vysoké učení technické v PrazeCzech Technical University in Prague, 2016)
      Mooring ropes used in offshore oil platforms are exposed to a set of extreme environmental conditions that can be crucial to their behaviour in service. Considering the elevated mechanical demands on these ropes imposed ...

    • EXPERIMENTAL EVALUATION OF WEDM MACHINED SURFACE WAVINESS 

      Autor: Mouralova , Katerina; Kovar , Jiri; Houska , Pavel
      (České vysoké učení technické v PrazeCzech Technical University in Prague, 2016)
      Wire Electrical Discharge Machining (WEDM) an unconventional machining technology which has become indispensable in many industries. The typical morphology of a surface machined using the electrical discharge technology ...

    • EXPERIMENTAL INVESTIGATION ON CHROMIUM(VI) REMOVAL FROM AQUEOUS SOLUTION USING ACTIVATED CARBON RESORCINOL FORMALDEHYDE XEROGELS 

      Autor: Oyedoh A., Eghe; Ekwonu C., Michael
      (České vysoké učení technické v PrazeCzech Technical University in Prague, 2016)
      The adsorption of chromium(VI) metal ion in aqueous solutions by activated carbon resorcinol formaldehyde xerogels (ACRF) was investigated. The results showed that pore structure, surface area and the adsorbent surface ...

    • IMPACT OF PLASTIC DEFORMATION ON THE PROPERTIES OF A SELECTED ALUMINIUM ALLOY 

      Autor: Lišková , Anna; Lacková , Petra; Mihaliková , Mária; Kočiško , Róbert
      (České vysoké učení technické v PrazeCzech Technical University in Prague, 2016)
      This paper reports on an experiment to assess the influence of plastic deformation on the microstructure and properties of EN AW 6012 (AlMgSiPb) aluminium alloy in two states. The first was the initial state with heat ...

    • OPTIMALIZATION OF AFTERBURNER CHANNEL IN BIOMASS BOILER USING CFD ANALYSIS 

      Autor: Pospíšil , Jiří; Lisý , Martin; Špiláček , Michal
      (České vysoké učení technické v PrazeCzech Technical University in Prague, 2016)
      This contribution presents the results of parametrical studies focused on the mixing process in a small rectangular duct within a biomass boiler. The first study investigates the influence of a local narrowing located in ...