Design of prequalified european beam-to-column connections for moment resistant frames with component based finite element method
Design of prequalified european beam-to-column connections for moment resistant frames with component based finite element method
Typ dokumentu
diplomová prácemaster thesis
Autor
Montenegro Eduarte Juan Sebastian
Vedoucí práce
Wald František
Oponent práce
Pošta Jan
Studijní obor
Sustainable Constructions under Natural Hazards and Catastrophic EventsStudijní program
Civil EngineeringInstituce přidělující hodnost
katedra ocelových a dřevěných konstrukcíPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato práce představuje studii zahrnující výpočet odporu spojů předběžně kvalifikovaných projektem EQUALJOINTS pomocí dvou různých přístupů: metodou komponent (CM) a metodou konečných prvků založenou na komponentách (CBFEM). V současné době je možné navrhnout připojení pouze metodami schválenými metodou Eurocodes, jako je metoda komponent nebo tabulky, s kapacitami spojů, avšak v případě, že připojení má neobvyklou typologii, je nutné provést test pro ověření připojení. Současná studie zkoumá kontrolu odporu spojů testovaných v laboratořích projektem EQUALJOINTS. Porovnává se jejich odolnost a deformační kapacita. CM bylo provedeno pomocí známých FIN EC a CBFEM s IDEA Statica. Tímto závěrem se všemi informacemi a výsledky dosaženými touto studií zamýšlí ověřit metodu, která je stále ve vývoji a dosud nebyla zahrnuta do Eurokódu. This dissertation presents a study involving the resistance calculation of connections prequalified by the EQUALJOINTS Project by using two different approaches: the component method (CM) and the component based finite element method (CBFEM). Nowadays, it is only possible to design connections by methods approved by Eurocodes like component method or tables with the capacities of the joints, but in the case where the connection has an uncommon typology it is required to perform test to validate the connection. The present study explores the resistance check of connections tested in labs by the EQUALJOINTS Project. A comparison between their resistances and deformation capacities is presented. The CM was performed using well-known FIN EC and the CBFEM with IDEA Statica. Thus, by concluding with all information and results achieved with this study, it is intended to validate a method which is still under development and has not yet been included in Eurocode.
Kolekce
- Diplomové práce - 11134 [610]