ČVUT DSpace
  • Search DSpace
  • Čeština
  • Login
  • Čeština
  • Čeština
View Item 
  •   ČVUT DSpace
  • Czech Technical University in Prague
  • Faculty of Mechanical Engineering
  • Department of Automotive, Combustion Engine and Railway
  • Master Theses - 12120
  • View Item
  • Czech Technical University in Prague
  • Faculty of Mechanical Engineering
  • Department of Automotive, Combustion Engine and Railway
  • Master Theses - 12120
  • View Item
JavaScript is disabled for your browser. Some features of this site may not work without it.

Porování přístrojů pro online měření částic ve výfukových plynech zážehových motorů s přímým vstřikem

Comparison of instrumentation for online measurement of particle emissions from direct injection spark ignition engines

Type of document
diplomová práce
master thesis
Author
Sairam Polasa
Supervisor
Vojtíšek Michal
Opponent
Pechout Martin
Field of study
Advanced Powertrains
Study program
Master of Automotive Engineering
Institutions assigning rank
ústav automobilů, spalovacích motorů a kolejových vozidel



Rights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.html
Vysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Show full item record
Abstract
This master thesis examines the suitability of online particle monitoring instruments for measurement of particle emissions from Direct Injection Spark Ignition (DISI) engines. A typical passenger car DISI engine was operated on gasoline and its mixtures with 25% iso-butanol and 25% n-butanol on a chassis dynamometer along speed and torque points corresponding to those measured during WLTC driving cycle on a typical midsize passenger car. Multiple cold and warm starts WLTC tests were conducted. Concentrations of particles in raw exhaust were measured by two particle classifiers, Engine Exhaust Particle Sizer (EEPS), Electrostatic Low-Pressure Impactor (ELPI), and by photoacoustic analyzer (Microsoot Sensor, MSS). Mean Total Particle Number Concentration measured by EEPS and ELPI and mean Total Particle Mass Concentration measured by MSS and derived from EEPS and ELPI measurements were compared. A reasonable agreement between the instruments (Particle Number Concentrations measured by EEPS and ELPI, Particle Mass Concentration measured by ELPI and MSS) was observed on gasoline, with somewhat high differences on butanol blends. High temperature version of ELPI, sampling raw exhaust, exhibited the high Signal to Noise ratio (SNR), followed by MSS and EEPS. In general, all instruments have shown a substantial decrease in particle emissions for both isomers of butanol relative to the gasoline, with relatively small differences between the two isomers. In general, all instruments provided useful measurements.
 
This master thesis examines the suitability of online particle monitoring instruments for measurement of particle emissions from Direct Injection Spark Ignition (DISI) engines. A typical passenger car DISI engine was operated on gasoline and its mixtures with 25% iso-butanol and 25% n-butanol on a chassis dynamometer along speed and torque points corresponding to those measured during WLTC driving cycle on a typical midsize passenger car. Multiple cold and warm starts WLTC tests were conducted. Concentrations of particles in raw exhaust were measured by two particle classifiers, Engine Exhaust Particle Sizer (EEPS), Electrostatic Low-Pressure Impactor (ELPI), and by photoacoustic analyzer (Microsoot Sensor, MSS). Mean Total Particle Number Concentration measured by EEPS and ELPI and mean Total Particle Mass Concentration measured by MSS and derived from EEPS and ELPI measurements were compared. A reasonable agreement between the instruments (Particle Number Concentrations measured by EEPS and ELPI, Particle Mass Concentration measured by ELPI and MSS) was observed on gasoline, with somewhat high differences on butanol blends. High temperature version of ELPI, sampling raw exhaust, exhibited the high Signal to Noise ratio (SNR), followed by MSS and EEPS. In general, all instruments have shown a substantial decrease in particle emissions for both isomers of butanol relative to the gasoline, with relatively small differences between the two isomers. In general, all instruments provided useful measurements.
 
URI
http://hdl.handle.net/10467/90330
View/Open
PLNY_TEXT (2.464Mb)
POSUDEK (116.8Kb)
POSUDEK (2.223Mb)
Collections
  • Diplomové práce - 12120 [456]

Related items

Showing items related by title, author, creator and subject.

  • Faktory ovlivňující jasnost značkovacích částic při měření metodou PIV 

    Author: Kiss Matěj; Supervisor: Hospodka Jakub; Opponent: Bartoš Ondřej
    (České vysoké učení technické v Praze. Vypočetní a informační centrum.Czech Technical University in Prague. Computing and Information Centre., 2016-05-17)
    Particle Image Velocimetry (PIV) je jednou z velmi pokročilých metod analýzy proudění v aerodynamice. Zcela zásadní podmínkou kvalitních výsledků při měření touto metodou je použití správného druhu značkovacích částic. ...
  • Metody PIV a PTV pro měření hladinových rychlostí 

    Author: Vít Petržílek; Supervisor: Nowak Petr; Opponent: Kantor Martin
    (České vysoké učení technické v Praze. Vypočetní a informační centrum.Czech Technical University in Prague. Computing and Information Centre., 2022-02-08)
    Cílem autora diplomové práce bylo ověření nestandardních metod měření, respektive metody particle image velocimetry a particle tracking velocimetry. Metody lze použít například pro měření hladinových rychlostí a vykreslení ...
  • Využití levných optických analyzátorů částic pro měření kvality vnitřního prostředí 

    Author: Tomáš Cetlovský; Supervisor: Vybíral Pavel; Opponent: Kučera Miroslav
    (České vysoké učení technické v Praze. Vypočetní a informační centrum.Czech Technical University in Prague. Computing and Information Centre., 2024-06-20)
    Práce se věnuje znečišťujícím látkám ve vnitřním prostředí, blíže se zaměřuje na tuhé znečišťující látky a frakce částic PMx. Popisuje základní metody měření koncentrace tuhých částic a hodnotí využití levných optických ...

České vysoké učení technické v Praze copyright © 2016 

DSpace software copyright © 2002-2016  Duraspace

Contact Us | Send Feedback
Theme by 
@mire NV
 

 

Useful links

CTU in PragueCentral library of CTUAbout CTU Digital LibraryResourcesStudy and library skillsResearch support

Browse

All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

My Account

Login

České vysoké učení technické v Praze copyright © 2016 

DSpace software copyright © 2002-2016  Duraspace

Contact Us | Send Feedback
Theme by 
@mire NV