Analýza mechanických vlastností 3D tisknutých dílů
Analysis of mechanical properties of 3D printed parts
Typ dokumentu
bakalářská prácebachelor thesis
Autor
Šimon Paleček
Vedoucí práce
Novák Vít
Oponent práce
Pilvousek Tomáš
Studijní obor
bez oboruStudijní program
Teoretický základ strojního inženýrstvíInstituce přidělující hodnost
ústav strojírenské technologiePráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Bakalářská práce se zabývá analýzou mechanických vlastností 3D tištěných dílů vytištěných z kovových materiálů a z kompozitního materiálu (polyamid s krátkými uhlíkovými vlákny). V úvodní teoretické části jsou uvedeny jednotlivé technologie 3D tisku. Dále jsou v teoretické části popsány principy zkoušek, které byly se vzorky prováděny. Zkoušky byly prováděny na tah, ohyb dále byla provedena zkouška rázem v ohybu. V praktické části byla porovnávána data z naměřených zkoušek. Data k jednotlivým zkouškám byla porovnávána ve skupinách rozdělených podle materiálu, podle orientace tisku, podle teploty během zkoušení. Vzorky byly porovnávány u zkoušky tahem podle maximálních hodnot dosažených napětí a dle maximální tažnosti. U zkoušky ohybem byly vzorky porovnávány podle maximální síly a maximálního průhybu před porušením vzorku. Při zkoušce rázem v ohybu byly vzorky porovnávány podle energie potřebné k přeražení testovacího vzorku. The bachelor thesis concerns itself with the analysis of mechanical properties of 3D printed parts using metallic materials and a composite material (polyamide with short carbon fibres). In the opening of the theoretical part individual 3D printing technologies are introduced. Next in the theoretical part the principles of the tests performed on the samples are described. The tests performed were the tensile test, the bend test and the impact test. In the practical part the data from the tests were compared. The data from each test were compared in groups divided according to material, direction of printing, testing temperature. With the tensile test, the samples were compared by the maximum values of stress and maximum ductility ratio. With the flexural test, the samples were compared by maximum strength and maximum buckling before the sample was damaged. With the impact test the samples were compared by energy needed to breach the tested sample.
Kolekce
- Bakalářské práce - 12133 [288]