Effect of Stress Induced Anisotropy on the Noise of Ring-core Fluxgate
Typ dokumentu
článek v časopisejournal article
Peer-reviewed
acceptedVersion
Autor
Butta M.
Ripka P.
Kraus L.
Práva
openAccessMetadata
Zobrazit celý záznamAbstrakt
In this paper we show how an anisotropy perpendicular to the direction of excitation is favourable to obtain low noise in fluxgate sensors. We produced ring cores by electroplating NiFe thin film (6 μm) over a bended copper substrate. After the electroplating process the sample was released and the back-stress induced anisotropy in the magnetic film due to magnetostriction of the material. As a result we obtained rings with regions showing hard behavior and orthogonal regions showing soft behavior. Then we used such rings as core for fluxgate and we measure both noise and sensitivity for different orientation of the ring in the pick-up coil. When the pick-up coil covers the area with anisotropy perpendicular to the direction of excitation the sensitivity is lower due to lower permeability but finally the noise is lower. On the other hand, rotating the core by 90 degrees the anisotropy becomes parallel to the direction of excitation and thus the sensitivity increases. Nevertheless, the noise also increases, showing that such anisotropy parallel to direction of excitation is unfavorable even if it brings higher sensitivity.
Zobrazit/ otevřít
Kolekce
- Publikační činnost ČVUT [1323]