Hlubinné založení slínkového sila v obci Ladce na Slovensku
Design of deep foundation of clinker silo in Ladce in Slovakia
Typ dokumentu
diplomová prácemaster thesis
Autor
Špedlová Veronika
Vedoucí práce
Masopust Jan
Oponent práce
Staněk Karel
Studijní obor
Konstrukce a dopravní stavbyStudijní program
Stavební inženýrstvíInstituce přidělující hodnost
katedra geotechnikyObhájeno
2017-02-15Práva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Předmětem této práce je posouzení založení slínkového sila pro uskladnění 85 000 tun slínku, které bylo realizováno v obci Ladce v západním Slovensku. Práce porovnává výsledky statické zkoušky piloty, která byla provedena v místě stavby, výsledky výpočtů podle obecně známých postupů a modelování v programu Plaxis 3D. Začátek této diplomové práce obsahuje kritické zhodnocení podkladů, které byly k dispozici pro návrh a posouzení založení. Dále jsou zde popsány konstrukce zásobníků a sil a porovnání různých druhů založení. Následuje podrobný popis konkrétního realizovaného sila - lokalita, tvar sila, zatížení a geotechnické parametry základové půdy. V dalších kapitolách je popsán vybraný způsob založení včetně jeho návrhu a posouzení. Nejprve je podrobně rozepsána statická zkouška, která byla provedena v místě stavby, poté je vypočítána únosnost osamělé piloty a na závěr je posouzeno sedání skupiny pilot. Následuje popis modelování v programu Plaxis 3D a nakonec porovnání výsledků. Součástí práce je také návrh výztuže pilot a monitoringu stavby. Přiloženy jsou výkresy založení. This thesis describes the designing of the foundations of a clinker silo in Ladce in Slovakia, which is supposed to bear 85 000 tons of clinker. The results of pile load test, results of calculations of the design, which follow the standard procedures, and results of Plaxis 3D designing are compared. At the beginning of this paper the design documents which are reviewed and different types of foundations are compared. Then the particular silo in question (that in Ladce) is described, including the dimensions, loading and geotechnical parameters of the soil at the building site. Calculation itself of the design follows: first of all, the foundation design is described and the pile load test results are explained. The bearing capacity of a single pile based on settlement is calculated and after that the settlement of a group of piles is also calculated. Then the Plaxis 3D design is described and finally the results are compared. There are also designs of the reinforcement, drawings and a draft of the monitoring of the settlement.