3D prototyping mechanizmů
3D prototyping of mechanism
Type of document
bakalářská prácebachelor thesis
Author
Havlan Tomáš
Supervisor
Zavřel Jan
Opponent
Beneš Petr
Field of study
bez oboruStudy program
Teoretický základ strojního inženýrstvíInstitutions assigning rank
ústav mechaniky, biomechaniky a mechatronikyDefended
2016-07-01Rights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://www.cvut.cz/sites/default/files/content/d1dc93cd-5894-4521-b799-c7e715d3c59e/cs/20160901-metodicky-pokyn-c-12009-o-dodrzovani-etickych-principu-pri-priprave-vysokoskolskych.pdfVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://www.cvut.cz/sites/default/files/content/d1dc93cd-5894-4521-b799-c7e715d3c59e/cs/20160901-metodicky-pokyn-c-12009-o-dodrzovani-etickych-principu-pri-priprave-vysokoskolskych.pdf
Metadata
Show full item recordAbstract
Bakalářská práce je zaměřena na problematiku rapid prototypingu (3D tisku) a jejího využití k tvorbě fyzických modelů mechanismů. V práci je popsána technologie 3D tisku od historie, principu, rozdělení a popsaní jednotlivých metod až po postup výroby modelů touto technologií. Dále je v práci zmíněna problematika kinematik mechanizmů, jejich rozdělení a stručný popis. Cílem práce je navrhnout z kinematického hlediska mechanismus typu delta, provést optimalizaci podle zadaných požadavků a následně model vytvořit pomocí 3D tisku. The bachelor thesis is focused on problems of rapid prototyping (3D printing) and its utilization for creation of physical models and mechanisms. In the thesis is described technology of 3D printing from history, principle, allocation and description of individual methods to the procedure of the model's manufacture with this technology. The kinetics issue of the mechanisms, its diversification and brief specification are also mentioned in this thesis. The goal of this thesis is to design from kinematical view, a delta type mechanism, fulfil optimalization following given requirements and afterwards to construct a model by using 3D printing.
View/ Open
Collections
- Bakalářské práce - 12105 [237]