Polohovací systém pro měření citlivosti RFID UHF tagů
Positioning system for RFID UHF tag sensitivity measurement
Type of document
bakalářská prácebachelor thesis
Author
Sviták Petr
Supervisor
Vojtěch Lukáš
Opponent
Neruda Marek
Field of study
Síťové a informační technologieStudy program
Komunikace, multimédia a elektronikaInstitutions assigning rank
katedra telekomunikační technikyRights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://www.cvut.cz/sites/default/files/content/d1dc93cd-5894-4521-b799-c7e715d3c59e/cs/20160901-metodicky-pokyn-c-12009-o-dodrzovani-etickych-principu-pri-priprave-vysokoskolskych.pdfVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://www.cvut.cz/sites/default/files/content/d1dc93cd-5894-4521-b799-c7e715d3c59e/cs/20160901-metodicky-pokyn-c-12009-o-dodrzovani-etickych-principu-pri-priprave-vysokoskolskych.pdf
Metadata
Show full item recordAbstract
Tato bakalářská práce je zaměřena na konstrukci polohovacího systému pro měření citlivosti RFID UHF tagů. Obsahuje potřebnou teorii pro vytvoření této konstrukce, stručné zdůvodnění použitých materiálů a ostatních komponentů. Mechanická konstrukce byla vytvořena z plexiskla. Pro polohování byly použity krokové motory, které jsou ovládané za pomoci mikrokontroléru Arduina a krokových stepper driverů RAMPS 1.4. Celé zařízení je navrženo jako příslušenství pro RFID čtečku vyvíjenou na ČVUT, fakultě elektrotechnické. Komunikace s RFID čtečkou probíhá po sběrnici SPI (Serial Peripheral Interface). This bachelor thesis is focused on the design and construction of a positioning system for measuring the sensitivity of UHF RFID tags. The thesis contains a theoretical part that explains the construction of the system, brief description and justification of used materials and other components. The mechanical construction was created from plexiglass. For the positioning part, stepper motors that are controlled by the Arduino microcontroller and stepper drivers RAMPS 1.4 were used. The entire device is designed as a component of the RFID reader which is being developed at the Czech Technical University, Faculty of Electrical Engineering. For communication with the RFID reader the SPI (Serial Peripheral Interface) is used.
Collections
- Bakalářské práce - 13132 [205]