Návrh a výroba vahadla odpružení
Design and manufacture of the suspension rocker arm
Type of document
bakalářská prácebachelor thesis
Author
Tomáš Zavadil
Supervisor
Slaný Michal
Opponent
Sucháček Petr
Field of study
bez oboruStudy program
Teoretický základ strojního inženýrstvíInstitutions assigning rank
ústav technologie obrábění, projektování a metrologieRights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Show full item recordAbstract
Práce se zabývá návrhem a výrobou sestavy vahadel systému zadního odděleného odpružení pro studentskou formuli. Část práce je zaměřená na volbu materiálů a výrobních technologií pro všechny díly sestavy, a část na mechanický návrh jak samotných vahadel, tak i jejich držáků, vložek a uložení. Je zde detailně popsán kompletní proces návrhu od vstupních sil a kinematiky až po finální díly. Součástí práce je taktéž vypracovaný výrobní postup pro jednotlivé díly celé sestavy. Výrobní postup je upraven, tak aby byla výroba možná v laboratořích Ústavu technologie obrábění, projektování a metrologie. Práce může být použita jako podklad pro návrh a výrobu dílů odpružení nové studentské formule. The thesis deals with the design and manufacture of a rear decoupled suspension system for a formula student car. Part of the work focuses on the choice of materials and manufacturing technologies for all parts of the assembly, and part on the mechanical design of the rockers themselves, as well as their brackets, inserts and mounting. The complete design process from input forces and kinematics to the final parts is described in detail. The work also includes a manufacturing procedure for the individual parts of the whole assembly. The manufacturing process is adapted to enable production in the laboratories of the Department of machining, process planning and metrology. The work can be used as a basis for the design and production of suspension parts of the new formula student car.
Collections
- Bakalářské práce - 12134 [376]