Ovlivnění řezných hran konstrukčních ocelí po plazmovém řezání
The affecting of cutting edges of structural steels after plasma cutting
Typ dokumentu
diplomová prácemaster thesis
Autor
Tomáš Bláha
Vedoucí práce
Kolařík Ladislav
Oponent práce
Kovanda Karel
Studijní obor
Bez specializaceStudijní program
Výrobní inženýrstvíInstituce přidělující hodnost
ústav strojírenské technologiePráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato diplomová práce se zabývá ovlivněním řezných hran konstrukčních ocelí po plazmovém řezání. Teoretická část popisuje základní metody tepelného dělení s bližším zaměřením na tepelné dělení plazmou. Dále vysvětluje a popisuje jednotlivé části plazmového hořáku. V praktické části se diplomová práce věnuje hodnocení velikosti tepelně ovlivněné oblasti po řezání a vyhodnocení kvality řezu (prostřednictvím měření tvrdosti řezných hran, úchylky kolmosti a měřením drsnosti povrchu - Rz5) na vybraných typech základních materiálů (konstrukční ocel S235 a Hardox 450). Uvedené charakteristiky jsou vyhodnocovány v souladu s normou ČSN EN 1090-2 přílohou D. This thesis deals with the influence of cutting edges of structural steels after plasma cutting. The theoretical part describes the basic methods of thermal cutting with a closer focus on plasma thermal cutting. It also explains and describes the different parts of the plasma torch. In the practical part, the thesis deals with the evaluation of the size of the thermally affected area after cutting and the evaluation of the quality of the cut (through the measurement of the hardness of the cutting edges, the perpendicularity deviation and the measurement of the surface roughness - Rz5) on selected types of basic materials (structural steel S235 and Hardox 450). These characteristics are evaluated in accordance with EN 1090-2 Annex D.
Kolekce
- Diplomové práce - 12133 [217]