ČVUT DSpace
  • Search DSpace
  • Čeština
  • Login
  • Čeština
  • Čeština
View Item 
  •   ČVUT DSpace
  • Czech Technical University in Prague
  • Faculty of Electrical Engineering
  • Department of Electromagnetic Field
  • Bachelor Theses - 13117
  • View Item
  • Czech Technical University in Prague
  • Faculty of Electrical Engineering
  • Department of Electromagnetic Field
  • Bachelor Theses - 13117
  • View Item
JavaScript is disabled for your browser. Some features of this site may not work without it.

Možnosti zlepšení parametrů trychtýřové antény pomocí dielektrické tyče

Horn Antenna Enhanced by 3D Printed DielectricRod

Type of document
bakalářská práce
bachelor thesis
Author
Roman Tyurin
Supervisor
Hazdra Pavel
Opponent
Kvičera Milan
Study program
Elektronika a komunikace
Institutions assigning rank
katedra elektromagnetického pole



Rights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.html
Vysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Show full item record
Abstract
V této práci je prezentována dielektrická tyč, která vylepšuje parametry trychtýřové antény. Tyč byla navržena pro trychtýř standardu WR187, jehož provozní pásmo je 3,95 až 5,85 GHz. Aby se dosáhlo přesnějších výsledků simulace, materiál, ze kterého se tyč vyrobila, byl extrahován měřením na vlnovodu. Finální model tyče byl vytištěn a proběhlo měření jak trychtýře samotného tak i se vsunutou dielektrickou tyčí. Po analýze měření se ukázalo, že tyč způsobila navýšení zisku průměrně o 5 dB. Činitel odrazu upravené antény se také vylepšil a je v celém jejím frekvenčním pásmu pod -17 dB. Anténa je směrovější než předtím, na což poukazují změřené vyzařovací diagramy.
 
Dielectric rod that enhances parameters of a horn antenna is presented in this thesis. The rod was design for a WR187 horn operating in the frequency range of 3.95 to 5.85 GHz. To achieve more precise results while simulating the rod, the material of the rod was extracted using waveguide measurements. The final model of the rod was printed, and both the horn and the horn with the dielectric rod were measured. After analyzing the measured data, it was found that the rod increased the antenna gain by an average of 5 dB. Reflection coefficient of enhanced antenna has also been improved and is below -17 dB across its entire frequency range. Radiation pattern indicates that antenna is more directional than before.
 
URI
http://hdl.handle.net/10467/109241
View/Open
PLNY_TEXT (26.26Mb)
POSUDEK (147.4Kb)
POSUDEK (810.3Kb)
Collections
  • Bakalářské práce - 13117 [141]

České vysoké učení technické v Praze copyright © 2016 

DSpace software copyright © 2002-2016  Duraspace

Contact Us | Send Feedback
Theme by 
@mire NV
 

 

Useful links

CTU in PragueCentral library of CTUAbout CTU Digital LibraryResourcesStudy and library skillsResearch support

Browse

All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

My Account

Login

České vysoké učení technické v Praze copyright © 2016 

DSpace software copyright © 2002-2016  Duraspace

Contact Us | Send Feedback
Theme by 
@mire NV