Střihačka kabelů řízená systémem ARDUINO
Cable cutter controlled by the ARDUINO system
Type of document
bakalářská prácebachelor thesis
Author
Lukáš Hlavatý
Supervisor
Hlinovský Vít
Opponent
Urban Ivan
Field of study
Aplikovaná elektrotechnikaStudy program
Elektrotechnika, energetika a managementInstitutions assigning rank
katedra elektrických pohonů a trakceRights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Show full item recordAbstract
Tato práce se zabývá návrhem a realizací automatizované střihačky kabelů, která je řízena mikrokontrolerem Arduino. Střihačka kabelů je vybavena krokovými motory, které zajišťují plynulý a přesný pohyb vodiče při stříhání. Práce se zaměřuje na návrh a implementaci elektronického obvodu, řídícího softwaru a mechanické konstrukce střihačky kabelů. Cílem práce bylo navrhnout funkční prototyp, který by umožňoval přesné odměřování a stříhání různých druhů vodičů s různými průřezy. V rámci práce byly provedeny také kontrolní testy a měření, které ověřily správnou funkčnost a přesnost střihačky. This thesis deals with the design and implementation of an automated cable cutter, which is controlled by an Arduino microcontroller. The cable cutter is equipped with stepper motors that ensure smooth and precise movement of the wire during cutting. This work focuses on the design and implementation of the electronic circuit, control software and mechanical structure of the cable cutter. The aim of the work was to design a working prototype that would allow accurate measuring and cutting of different types of wires with different cross-sections. As part of the work, control tests and measurements were also performed to verify the correct functionality and accuracy of the cutter.
Collections
- Bakalářské práce - 13114 [128]