COMPRESSIVE PROPERTIES OF AUXETIC STRUCTURES WITH CONTROLLED STIFFNESS OF STRUT JOINTS
Type of document
articlePeer-reviewed
publishedVersion
Author
Doktor, Tomáš
Fíla, Tomáš
Koudelka, Petr
Kytýř, Daniel
Jiroušek, Ondřej
Rights
Creative Commons Attribution 4.0 International Licensehttp://creativecommons.org/licenses/by/4.0/
openAccess
Metadata
Show full item recordAbstract
Presented paper deals with experimental study on compressive properties of auxetics with controlled stiffness of strut joints. The variable strut joints properties were simulated by adding extra amount of material in the struts’ intersection regions. Four groups of inverted honeycomb structures were prepared by multi-jet 3D printing and tested in quasi-static compression. The structure collapsed gradually, however after the first collapse, failure in entire cross-section occurred due to the brittle nature of the base material. The behavior up to the first collapse was consistent among the specimens within each group, while differed slightly subsequently. With higher reinforcement in the joints, results showed increasing stress at the first collapse (ultimate compressive stress) while the strain at the first collapse remained unchanged. The auxetic behaviour became less significant with increasing joints’ reinforcement.
Collections
The following license files are associated with this item:
Except where otherwise noted, this item's license is described as Creative Commons Attribution 4.0 International License