Návrh zařízení pro ohřev vzorku pro zkoušku tahem
Design of heating device for tensile test
Typ dokumentu
diplomová prácemaster thesis
Autor
Jiří Dvořáček
Vedoucí práce
Valeš Michal
Oponent práce
Pačák Tomáš
Studijní obor
Bez specializaceStudijní program
Výrobní inženýrstvíInstituce přidělující hodnost
ústav strojírenské technologiePráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato diplomová práce se zabývá návrhem zařízení pro ohřev vzorku pro zkoušku tahem a ověřením jeho funkčnosti. Teoretická část seznamuje čtenáře s problematikou zkoušení vlastností materiálu, popisuje metody přenosu tepla, ohřevu materiálu a měření teploty. Dále jsou v rámci teoretické části také popsány základy deformačního chování materiálů a zkoušky tahem. V praktické části jsou s využitím zjištěných poznatků porovnány metody ohřevu a měření teploty a je provedeno experimentální měření. Diskuze popisuje faktory ovlivňující experiment a uvádí doporučení pro budoucí měření. Výsledkem této práce je návrh zařízení pro ohřev vzorku pro zkoušku tahem. This diploma thesis deals with the design of a device for heating a sample for a tensile test and the evaluation of its functionality. The theoretical part introduces the reader to the issue of testing material properties and describes methods of heat transfer, heating of the material, and temperature measurement. Furthermore, the basics of the deformation behavior of materials and tensile tests are also described in the theoretical part. In the practical part, the heating and temperature measurement methods are compared using the found information, and an experimental measurement is carried out. Finally, the discussion describes the factors affecting the experiment and recommends future measures. The result of this thesis is the design of a device for heating the sample for the tensile test.
Kolekce
- Diplomové práce - 12133 [236]