Problematika výroby plastového dílu
Problematik of design and productin plastic part
Typ dokumentu
bakalářská prácebachelor thesis
Autor
Lukáš Minka
Vedoucí práce
Herman Aleš
Oponent práce
Zeman Lubomír
Studijní obor
bez oboruStudijní program
Teoretický základ strojního inženýrstvíInstituce přidělující hodnost
ústav strojírenské technologiePráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato bakalářská práce se zabývá technologií vstřikování plastů a také návrhem designu plastové podpěry. Teoretická část popisuje princip vstřikování plastů, práci vstřikolisu v jednotlivých fázích vstřikovacího cyklu, výběr vhodného materiálu pro vstřikování, polymery a jejich rozdělení. Dále se zabývá technologičností konstrukce, tedy technologicko – konstrukčními prvky, které jsou velice důležité při návrhu výstřiku. Praktická část se věnuje návrhu designu podpěry, sloužící pro upevnění vodiče hromosvodu ke zdi, která bude vyráběna firmou Tremis s.r.o., což je zadavatel této práce. Dále se zaobírá výběrem materiálu podpěry a simulací vstřikování podpěry v softwaru CADMOULD. Cílem a zároveň výsledkem této práce jsou návrhy dvou variant designu podpěry, včetně zvoleného materiálu a provedení simulace vstřikování s chlazením a horkým vtokem. This bachelor thesis deals with the technology of plastic injection moulding and also the design of conductor support. The theoretical part describes the principle of plastic injection, the work of the injection moulding machine in the individual phases of the injection cycle, the selection of a suitable material for injection moulding, polymers and their categorisations. It also deals with the technological design, i.e. technological-structural elements that are very important in the design of the mould. The practical part is devoted to the design of a conductor support, used to attach the conductor to the wall. The support will be manufactured by Tremis s.r.o., who are the client of this project. It also deals with the selection of support material and simulation of support injection in CADMOULD software. The aim and achieved result of this work are the design of two variants of the conductor support design, including the selected material and the implementation of the injection simulation with cooling system and hot runner.
Kolekce
- Bakalářské práce - 12133 [283]