Testování GNSS modulu Ublox 9.generace
Testing GNSS modul Ublox 9th generation
Typ dokumentu
diplomová prácemaster thesis
Autor
Jan Šikola
Vedoucí práce
Vyskočil Zdeněk
Oponent práce
Hodík Štěpán
Studijní obor
GeomatikaStudijní program
Geodézie a kartografieInstituce přidělující hodnost
Katedra geomatikyPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato diplomová práce se zabývá testováním nové generace GNSS modulu od společnosti Sparkfun s čipem u-blox ZED-F9P. GNSS modul byl testován společně s anténou u-blox ANN-MB. Tato GNSS aparatura umožňuje příjem a zpracování signálů L2, které předchozí generace tohoto zařízení neumožňovaly. Zařízení bylo podrobeno celkem čtyřem testům, kde byla zkoušena statická metoda i měření v reálném čase. Měření GNSS aparaturou proběhlo pomocí programu U-center. V poslední části práce je popsán postup vytvoření NTRIP Clienta pro přijímání korekcí v reálném čase na platformě Arduino s vývojovou deskou Arduino Due a GMS/GPRS modulem SIM800L. This master thesis deals with testing a new generation GNSS board from Sparkfun with the u-blox ZED-F9P module. The GNSS board was tested together with the u-blox ANN-MB antenna. This GNSS receiver allows the reception and processing of L2 signals which previous generations of this device did not allow. Four tests were acomplished by this device,where the static method and real-time measurement were tested. The data from measurements by GNSS receiver were recorded by U-center. The last part of this thesis describes the procedure of creating an NTRIP Client for receiving real-time corrections on the Arduino platform with the Arduino Due development board and the GMS / GPRS module SIM800L.
Kolekce
- Diplomové práce - 11155 [153]