Ověření mikromechanických vlastností feriticko-martenzitických ocelí pomocí vysokoteplotní nanoindentace
Assessment of high temperature micromechanical properties of ferrictic-martensitic steels by nanoindentation
Typ dokumentu
diplomová prácemaster thesis
Autor
Růžička Jan
Vedoucí práce
Dostál Václav
Oponent práce
Kříž Antonín
Studijní obor
Jaderná energetická zařízeníStudijní program
Jaderná energetická zařízeníInstituce přidělující hodnost
ústav energetikyPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato diplomová práce se zabývá vysokoteplotní nanoindentací feriticko-martenzitických ocelí, konkrétně oceli EUROFER 97. Obsah práce začíná studií o současných reaktorových ocelích, jejich chování a degradaci. Následuje stručný popis metod mechanického testování ozářených materiálů za účelem porovnání s technikou nanoindentace, která je popsána v širším kontextu. Experimentální část zahrnuje metalografickou přípravu, analýzu pomocí několika metod mikroskopie a samotnou nanoindentaci. Ta byla provedena na třech oblastech s odlišnou finální povrchovou úpravou - elektrolytické leptání/leštění a OPS, při teplotách od 23°C do 700°C, v rozsahu zatížení - 5, 10, 50 a 100 mN. Na závěr jsou uvedena doporučení týkající se postupu přípravy vzorků i nanoindentace založená na diskutovaných výsledcích. This master´s thesis deals with high-temperature nanoindentation testing of ferritic/martensitic steels, specifically the EUROFER 97. The content of this work starts with a study of present reactor materials, their behaviour and degradation. Conventional methods of mechanical testing to determine the irradiated material properties are briefly described, to be able to compare them with nanoindentation technique that is introduced in greater context. The work then continues with an experimental part that contains metallography, microscopy and the nanoindentation itself. The nanoindentation was conducted on three areas - electro etching/polishing and OPS, at temperatures ranging from 23°C up to 700°C under load range of - 5, 10, 50 and 100 mN. Finally, a series of recommendations based on presented results and subsequent discussion was derived as a conclusion of this thesis.
Kolekce
- Diplomové práce - 12115 [186]