Návrh poloautomatické montážní stanice konektoru s O-kroužkem
Design of Semiautomatic Assembly of Connector with O-ring
Typ dokumentu
diplomová prácemaster thesis
Autor
Noháč Marek
Vedoucí práce
Mrázek Jiří
Oponent práce
Vosecký Miloš
Studijní obor
Dopravní, letadlová a transportní technikaStudijní program
Strojní inženýrstvíInstituce přidělující hodnost
ústav konstruování a částí strojůPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Lisování zaujímá ve strojírenství podstatnou část spojení součástí především z důvodu jeho nízké ceny a možností vysokých přenosů sil a výkonů. Teoretická část této práce je zaměřena na souhrn informací ohledně lisování, jeho kvalitě a možnosti řízení při lisování, a to především se zaměřením na součásti typu náboj-hřídel, ale i instalace O-kroužků do drážek a způsoby jejich výpočtu. Úkolem praktické části práce je na základě získaných informací z norem o lisování a ze zadání požadavků zákazníka vytvořit návrhový model zařízení, na kterém by bylo možné provádět lisování O-kroužků na konektor a následné zalisování konektoru do tělesa. Pressing occupies a significant part of the joining of parts in mechanical engineering, mainly due to its low price and high power transmission capabilities. The theoretical part of the thesis focused on the summary of information on pressing, its quality and the possibilities of stamping, especially with focus on hub-shaft components, as well as installation of O-rings in the grooves and ways of their calculation. The task of the practical part of the thesis is based on the obtained information from the standards of pressing and the requirements of the customer to create a design model of the device on which it is possible to perform the O-ring pressing on the connector and the subsequent pressing of the connector into the body.
Kolekce
- Diplomové práce - 12113 [201]