Návrh a konstrukce soft startéru pro asynchronní motory do 5KW
Design and Realization of Softstarter for Induction Machine with Power about 5 kW
Typ dokumentu
diplomová prácemaster thesis
Autor
Kroupa František
Vedoucí práce
Bauer Jan
Oponent práce
Bráza Josef
Studijní obor
ElektroenergetikaStudijní program
Elektrotechnika, energetika a managementInstituce přidělující hodnost
katedra elektroenergetikyObhájeno
2017-01-31Práva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Tato diplomová práce se zabývá problematikou spouštění asynchronních motorů s kotvou nakrátko a především návrhem a konstrukcí zařízení Soft startér, pomocí kterého jsou tyto rozběhy realizovány. Cílem práce bylo navrhnout a realizovat levné zařízení z běžně dostupných komponent pro rozběh pohonů instalovaných v malých domovních jednotkách tepelných čerpadel. Samotný návrh se dělí na čtyři úrovně, a to 1) stanovení požadavků na zařízení, 2) návrh topologie zapojení soft startéru, 3) návrh výkonové části, volba aktivních a pasivních prvků a jejich dimenzování, 4) návrh řídící části, algoritmy řízení, časování a měření potřebných veličin. Zařízení soft startér bylo zkonstruováno a úspěšně otestováno. This thesis deals with the starting of induction squirrel-cage motors and mainly with the design and construction of "Soft starter" which carries out the starting of the motor. The aim of the thesis was to design and implement an inexpensive device from readily available components for starting of drives installed in small residential heat pumps. The design itself is divided into four levels, namely 1) determination of the requirements for device, 2) design of "soft starter" topology diagram, 3) design of power section, the choice of active and passive components and dimensioning, and 4) design of control part, control algorithms, timing and measuring of the required parameters. Soft starter has been constructed and successfully tested.
Kolekce
- Diplomové práce - 13115 [382]