Výpočetní nástroj pro optimální dimenzování zdroje kombinované výroby elektřiny a tepla
Computational tool for optimal sizing of combined heat and power sources
Typ dokumentu
diplomová prácemaster thesis
Autor
Martin Lukeš
Vedoucí práce
Klein Vít
Oponent práce
Šváb Michal
Studijní obor
ElektroenergetikaStudijní program
Elektrotechnika, energetika a managementInstituce přidělující hodnost
katedra elektroenergetikyPráva
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Zobrazit celý záznamAbstrakt
Diplomová práce se v teoretické části zabývá popisem kombinované výroby elektřiny a tepla, kogeneračních jednotek, porovnání se samostatnou výrobou elektřiny a tepla, návrhem kogenerační jednotky a ekonomickým zhodnocení investic. Tyto informace jsou pak využité v praktické části, která se zabývá tvorbou výpočetního nástroje pro dimenzování kogenerační jednotky. Praktická část obsahuje popis elektrické a tepelné spotřeby. Dále tu jsou popsány vybrané varianty a nástroj, který byl vytvořen ve Wolfram Mathematica. Spotřeby a parametry vybraných variant byly vloženy do nástroje a z nástroje jsme poté dostali technické výsledky. Ty byly v nástroji dále využity k ekonomickému zhodnocení. Dále zde jsou provedeny citlivostní analýzy vstupních parametrů. The theoretical part of the thesis deals with the description of combined production of electricity and heat, cogeneration units, comparison with separate production of electricity and heat, design of cogeneration unit and economic evaluation of investments. This information is then used in the practical part, which deals with the development of a calculation tool for sizing the cogeneration unit. The practical part contains a description of the electrical and thermal consumption. It also describes selected variants and the tool, which was developed in Wolfram Mathematica. The consumption and parameters of the selected variants were entered into the tool and the technical results were then obtained from the tool. These were further used in the tool for economic evaluation. In addition, sensitivity analyses of the input parameters are performed.
Kolekce
- Diplomové práce - 13115 [388]