Vliv temperace na 3D tištěné vzorky z polymerního materiálu
Influence of tempering on 3D printed samples from polymer material
Type of document
diplomová prácemaster thesis
Author
Tomáš Krupka
Supervisor
Jeníková Zdeňka
Opponent
Melichar Jakub
Field of study
Bez specializaceStudy program
Výrobní inženýrstvíInstitutions assigning rank
ústav materiálového inženýrstvíRights
A university thesis is a work protected by the Copyright Act. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one?s own expense. The use of thesis should be in compliance with the Copyright Act http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf and the citation ethics http://knihovny.cvut.cz/vychova/vskp.htmlVysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem http://www.mkcr.cz/assets/autorske-pravo/01-3982006.pdf a citační etikou http://knihovny.cvut.cz/vychova/vskp.html
Metadata
Show full item recordAbstract
Diplomová práce na téma vliv temperace na 3D tištěné vzorky z polymerního materiálu představuje informace o aditivních technologiích používaných pro 3D tisk polymerních materiálů. Zvláště pak technologií fused deposition modeling (FDM) a materiálu glykolem modyfikovaný poethylentereftalát (PETG) a kompozitem PETG s uhlíkovým vláknem a možností tepelného zpracování výtisku z nich vyrobených. Dále se práce zabývá výrobou zkušebních tělísek z PETG a PETG s uhlíkovým vláknem a jejich žíháním při různých teplotách. Následně jsou provedeny zkoušky mechanických vlastností. Závěr práce tvoří porovnání mechanických vlastností obou materiálů a dosažených změn po žíhání. The thesis on the effect of tempering on 3D printed polymer material samples presents information on additive technologies used for 3D printing of polymer materials. In particular, fused deposition modelling (FDM) technology and the material glycol modified polyethylene terephthalate (PETG) and PETG-carbon fibre composite and the possibility of heat treating prints made from them. Furthermore, the work deals with the fabrication of PETG and PETG with carbon fibre test bodies and their annealing at different temperatures. Subsequently, mechanical properties tests are performed. The thesis concludes with a comparison of the mechanical properties of the two materials and the changes obtained after annealing.
Collections
- Diplomové práce - 12132 [109]