Measurement of the elastokinematics of wheel suspension
Měření elastokinematiky zavěšení vozidla
Authors
Supervisors
Reviewers
Editors
Other contributors
Journal Title
Journal ISSN
Volume Title
Publisher
České vysoké učení technické v Praze
Czech Technical University in Prague
Czech Technical University in Prague
Date of defense
2019-02-07
Abstract
The aim of this dissertation is to study "Elastokinematics of wheel suspension" of Škoda Superb 4X4, with the existing test bench in the laboratory of Automotive Department at Juliska. Primarily, I performed detail analysis of previous studies on elastokinematic test bench. Next, I refurbished the old setup, retraced the measurements and prepared the data acquisition software in LabVIEW. obtained results plotted into graphs, analysed and compared with the previous results. In addition to this, I proposed the solution for the sliding mechanism and checked the feasibility of suggested guides with the parameters provided by manufacturer. Designed and fabricated the measurement setup for the left wheel (i.e. sliding table, sensors stand, height sensor mount and the wheel clamp) to measure the change in elastokinematic parameters of left wheel in a car. Detail study of the measured data with edited test bench and suggested the possibilities of the future improvement.
The aim of this dissertation is to study "Elastokinematics of wheel suspension" of Škoda Superb 4X4, with the existing test bench in the laboratory of Automotive Department at Juliska. Primarily, I performed detail analysis of previous studies on elastokinematic test bench. Next, I refurbished the old setup, retraced the measurements and prepared the data acquisition software in LabVIEW. obtained results plotted into graphs, analysed and compared with the previous results. In addition to this, I proposed the solution for the sliding mechanism and checked the feasibility of suggested guides with the parameters provided by manufacturer. Designed and fabricated the measurement setup for the left wheel (i.e. sliding table, sensors stand, height sensor mount and the wheel clamp) to measure the change in elastokinematic parameters of left wheel in a car. Detail study of the measured data with edited test bench and suggested the possibilities of the future improvement.
The aim of this dissertation is to study "Elastokinematics of wheel suspension" of Škoda Superb 4X4, with the existing test bench in the laboratory of Automotive Department at Juliska. Primarily, I performed detail analysis of previous studies on elastokinematic test bench. Next, I refurbished the old setup, retraced the measurements and prepared the data acquisition software in LabVIEW. obtained results plotted into graphs, analysed and compared with the previous results. In addition to this, I proposed the solution for the sliding mechanism and checked the feasibility of suggested guides with the parameters provided by manufacturer. Designed and fabricated the measurement setup for the left wheel (i.e. sliding table, sensors stand, height sensor mount and the wheel clamp) to measure the change in elastokinematic parameters of left wheel in a car. Detail study of the measured data with edited test bench and suggested the possibilities of the future improvement.
Description
Keywords
Citation
Permanent link
Rights/License
A university thesis is a work protected by the Copyright Act of the Czech Republic. Extracts, copies and transcripts of the thesis are allowed for personal use only and at one`s own expense. The use of thesis should be in compliance with the Copyright Act.
Vysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem v platném znění.
Vysokoškolská závěrečná práce je dílo chráněné autorským zákonem. Je možné pořizovat z něj na své náklady a pro svoji osobní potřebu výpisy, opisy a rozmnoženiny. Jeho využití musí být v souladu s autorským zákonem v platném znění.